A Lil help needed

[addie]

Ppi 760.4
2 fe200 6" 4 ohms
2 fe200 8" 8 ohms bridge
DD m1c
2 512DD subs
9500 bt pioneer
2 nb 1 tweets powered of the deck

Experienced installers and audio men tell me what you think of this setup and and what can be done to improve it .

[addie]

No reply as yet boy

[- Rovin's car audio -]

ppl only studying how they gonna fete tonight so d 4rum dead right now


that is a nice simple system ...

[addie]

Any suggestions for processing

[Team2lo2flo]

You can use a Pioneer 80 PRS headunit and maybe forego any external processing

[meccalli]

Trash those tweets, can't stand those personally. Those big plastic piezos sound better imo and can be improved with a little modding and attenuation.

[ruffneck_12]

ent, dem NB1's does make everything sound like a hiss

[nervewrecker]

Where you placing the speakers?

Any particular reason as to why you chose speakers of different impedance? You could have wired each pair in parallel off a pair of bridged channel off the amp and maximized the power output.
Depending on the frequency range you want to cover you could have done a 6" and 8" for left and right respectively.

Ditto on the nb1's but if you like how they sound then by all means install them.

[addie]

Nb1 for the small size and low wattage and the 8" would be bridged and placed on the back dash

Plz recommended better tweets of a similar size I don't like the size of bullet tweets

[nervewrecker]

The 8's for the back and 6's for the front then? Just a "front fill"?

Get a decent pair of Titanium tweets and for them on the backdash or up front.

[addie]

Just a (front fill ) explain!

[nervewrecker]

Well they have less surface area than the 8's and will get half the power. Plus the 8's have nothing blocking them so they just up front to fill in, help when you park and play and not make it sound like all the music coming from the rear.

[addie]

Does it make sense putting the two 6.5" in the back with two small compression drivers like the d220 ti selenium

[addie]

Bump