Moderator: 3ne2nr Mods
mojosodope wrote:I doubt any survived, do a fishless cycle and reestablish your bio from start to avoid any problems, spare the fish.
link wrote:mojosodope wrote:I doubt any survived, do a fishless cycle and reestablish your bio from start to avoid any problems, spare the fish.
ditto...but u already hve algae growth...toss in a couple 'never-die' local tata...u'll restart w/o an algae attack
rgds
mojosodope wrote:Contemplating buying an Apex Lite from neptune systems, anyone have any experience with their products?
greenlime100 wrote:Question.....
I have also koi pond, its indoors and doesnt have much light beside three 35w bulbs that are in the water. Are there any plants you know of that would grow there? Just a name would be fine ill do the necessary research after.
Fishman wrote:mojosodope wrote:Contemplating buying an Apex Lite from neptune systems, anyone have any experience with their products?
I run the full Apex as it has the variable speed ports that I use for light dimming and has two pH ports. I use one to control my calcium reactor, and the other to monitor my aquarium. As far as I am concerned it is the best investment I have made on my reef. It's saved me a couple of times by emailing me when parameters were off. One time my chiller had tripped its GFCI and so never turned on, when my temp got too high the Apex shut down my lights and saved it from going higher. Also there are apps for iOS and Android, so you can turn on and off anything plugged into it right from your phone.
Fishman wrote:cichlidboi wrote:ziggy_dappa wrote:cichlidboi wrote:Fishman wrote:cichlidboi wrote:arite cool thanks again fishman, another thing u know where i could buy lld meanwell drivers the wired ones preferably but i dont mine the other one either. what about timers, lld pwm i believe i hadda use a controller if i wanna dim or it has another way?
I haven't bought as yet as I am still in the planning stages of my new LED build so I am not sure. Also don't use timers, look into a controller. My plan is to use my Apex with these drivers. The problem is that the Apex puts out a 0-10V signal and the LDD uses a PWM signal. The plan is to get a PWM harness from SteveLED's which converts 0-10V to PWM.
Look into an Arduino build, you can do some really cool things with them.
ok cool well i looking into an arduino build but i hoping i could find some sample code cause while i know a bit of code it might suck to right from scratch.
Check out the Typhon controller from BoostLed, its an arduino led controller with a screen and is already programed for $55.00
http://www.boostled.com/product_p/typhon.htm
ok so i check out the controller it cool but it only have 4 channels, wish it had atleast 5 but good controller nonetheless ill keep it in mind when considering my options.
That's why I will be sticking with the Apex and converting the signal with a harness. The Apex comes with 4 channels but can be expanded by adding modules. Each module adds 4 more. Steve's conversion harness can handle 4 channels each. I am planning 6-8 channels depending on my final design.
kl122 wrote:Any one else knew we have silver hatchet fish in the swamps down here? Caught two down plum mitan display week while fishing for cascadoo
DFC wrote:I still think having fish as pets is gay and sad.
Rooki3 wrote:dem big orglee fish in club aquarios is wah kind?
DFC wrote:I still think having fish as pets is gay and sad.
But this is kinda cool.
Return to “Ole talk and more Ole talk”
Users browsing this forum: No registered users and 8 guests