Energy Sector Thread - Operators, Engineers, Technicians Et Al

[sMASH]

Well, they swore themselves to secrecy, so they will take any jamming offered. Justified or not.

Panzzies.


Me, i preferred to take down turbine via the steam inlet. Just make. Sure that it coasts down and doesn't begin to backspin. And. In that case, if u can throttle the discharge to prevent flow or open up the steam inlet a bit to give it more forward rotation.

But then again I grew up with valves seating off well and check valve holding. That fertilizer place, half the things don't work properly and the other half fail in a timing.


And then again, when I left where I grew up, a short time after HP boiler tunes went shooting into The reformed gas piping leaving the boiler. And before that distribution laterals were ejected from the side of a cooling tower. I called that the M4 attempt at a space program.

[De Dragon]

Reformer damage nothing new with them. I remember few years ago when over a hundred tubes were damaged on M1 plant. Set a crackshots

Pfft, M3 destroyed all 384 of theirs in the early, TTMC days

[Cantmis]

Wilson_The_Volleyball.jpg (10.98 KiB) Viewed 5320 times

[sMASH]

Reformer damage nothing new with them. I remember few years ago when over a hundred tubes were damaged on M1 plant. Set a crackshots

Pfft, M3 destroyed all 384 of theirs in the early, TTMC days

Thst guy got large after

[vaiostation]

"Resignations" incoming!!!
"Promotions" incoming!!!

[DreamWeaver]

"Resignations" incoming!!!
"Promotions" incoming!!!

for real. in typical fashion. you forgot the "suspensions" incoming! though

[eitech]

"Resignations" incoming!!!
"Promotions" incoming!!!

Promotions not saving the resignations nah

[trinidrift]

Anyone heard bp want operators? Can someone send the link if you have it?

[Kixy]

Jus heard upstream reformer tubes blow out

daz it? daz small thing. m4 was blowing tubes every week earlier this year. lol. crimp tube and start back up then?

Dats not small thing d reformer blow up...

Nobody get a picture or video of this yet?

Apparently d damage rel bad, i heard ammonia gonna be down for a good few months.

[eitech]

Jus heard upstream reformer tubes blow out

daz it? daz small thing. m4 was blowing tubes every week earlier this year. lol. crimp tube and start back up then?

Dats not small thing d reformer blow up...

Nobody get a picture or video of this yet?

Apparently d damage rel bad, i heard ammonia gonna be down for a good few months.

Well i heard it was real bad too. Proman already inside. Heard they project 3- 6 wks. My padna done say he fed up pull burnt cables. Lol

[gencon]

A link is right. That's the hiring medium now.

was home for almost 2 years got a link up because of networking, got a position as quality control technician 2-3 year contract and I doh even have a degree

[nervewrecker]

A link is right. That's the hiring medium now.

was home for almost 2 years got a link up because of networking, got a position as quality control technician 2-3 year contract and I doh even have a degree

Thats how you do it. Gotta make yourself known.

[gencon]

A link is right. That's the hiring medium now.

was home for almost 2 years got a link up because of networking, got a position as quality control technician 2-3 year contract and I doh even have a degree

Thats how you do it. Gotta make yourself known.

check out all your friends from primary, secondary and tertiary school. look for them on facebook and linkedin.

[sinister_14]

D GAS COMPANY START TAGGING GAS VALVES ON CERTAIN PLANTS ON D ESTATE COME DECEMBER NO MORE GAS FOR THESE PLANT......REAL SORRY FOR THESE EMPLOYEES....

[jhonnieblue]

D GAS COMPANY START TAGGING GAS VALVES ON CERTAIN PLANTS ON D ESTATE COME DECEMBER NO MORE GAS FOR THESE PLANT......REAL SORRY FOR THESE EMPLOYEES....

Contract negotiations still ongoing so they will prob have a monthly renewal

[De Dragon]

D GAS COMPANY START TAGGING GAS VALVES ON CERTAIN PLANTS ON D ESTATE COME DECEMBER NO MORE GAS FOR THESE PLANT......REAL SORRY FOR THESE EMPLOYEES....

Yet it is constant gas curtailments to the companies that have existing contracts.

[Cantmis]

[DreamWeaver]

D GAS COMPANY START TAGGING GAS VALVES ON CERTAIN PLANTS ON D ESTATE COME DECEMBER NO MORE GAS FOR THESE PLANT......REAL SORRY FOR THESE EMPLOYEES....

which plants???

[gencon]

FB_IMG_1511317791581.jpg

I still send my Resume even though I am not in health and safety.

[K74T]

[Numb3r4]

^^^ Got any more details on that company...they are asking for a lot of details and their site seems a bit sparse.

Is it legit....little to no info. on anything. I know the employers want to be anonymous but....

For those interested

https://recruityoutt.com/

https://recruityoutt.com/job

[K74T]

I can’t confirm but I believe it’s Massy Energy.

[Numb3r4]

I can’t confirm but I believe it’s Massy Energy.

Why are they trying to be anonymous......they would often post on Caribbean Jobs and in the papers with their Company advertised.

I though it was good PR to be advertising the fact that you are hiring.

[trinidrift]

I thought it looked like stork or smscl

[Helena_Victor]

Anybody submitted their application and didnt get an error msg?

[Helena_Victor]

Anybody submitted their application and didnt get an error msg?

if anyone knows who this company is then please let me know because my applications are not going through at all. I would like to contact them directly to let them know what's happening.

[Helena_Victor]

Oh in case anyone is interested, CGCL has vacancies on their website..

[Allergic2BunnyEars]

Potential jobs in pic.

[Numb3r4]

Anybody submitted their application and didnt get an error msg?

if anyone knows who this company is then please let me know because my applications are not going through at all. I would like to contact them directly to let them know what's happening.

They have advertised again and still the site does not work....

"Please match the requested format"

[DreamWeaver]

any update on if the ngc still gonna shut down plants by d end of the year?