Nissan tiida issue update

[vipervega]

Ok tuners its the tiida with the CVT
Car starts and idles normal
As u try to put it in a gear may it be drive or reverse the car cuts off
If however you rev the car to about 2000 rpm in neutral n engage the gear it stays idling....but when u start to drive there is a severe power loss....

If u put it back in part or neutral and try to put it in drive ....it will stall again....unless u rev it n engage the gear.....

Anybody can help with this issue or have any idea?

[ZeenRB]

run a diagnostic on the car.... i had the same issue, the mechanic took out the "throttle" cleaned it with wd40 n put it back in....problem solved

[vipervega]

Thanks do u know any mechanic that know about these cars? Who sorted you out?

[vipervega]

:grin::grin::grin:

[ZeenRB]

i went to AutoBoss in penal...car works real good now...will hv to get the number for u

[vipervega]

Thanks still need help with this issue as I can't drive car....

[vipervega]

Clean throttle body and air flow today same issue also the check light came on.this time need someone to come scan it for me

[vipervega]

Update car get a code p1740 -cvt torque converter clutch lock up solenoid-malfunction

So I hadda get that solenoid sensor

[vipervega]

Got the solenoid changed it same problem.....prior to this the car throw 2 codes the transmission code and a cylinder misfire code.......do u guys think the coilpacks can cause the tranny to malfunction like this?.....we changed the lock up solenoid but the one that was in the tranny wasn't bad in the first place....even though the scan show that it was......I need a good electrician to come see if its an electrical issue

[Stixer7]

ThE one time I dealt with this was due to a faulty battery
The solenoid is getting under current thus not activating thus the code

When last was this battery changed?

45 for a fu tranny

50 to fix