trinituner.com

Bad bearing, long story.
Anyone knows who does repairs like these?
I need to find out like...yesterday....
Need the bearing replaced by weeks end if possible

with that being said....can anyone link a contact?

they whole wheel hub may need to be changed but somewhere before someone mentioned that it is cheaper in the bamboo to get the hubs.N&M has the entire wheel hub for like $3-4000 whereas it available outside for half the price. both sides should ideally be replaced at the same time.i was caught between a rock and a hard place and had to purchase from the firm is the symptom an extremely loud noise?i think it may have been light hammer who sourced them outside possibly at ROC but i could be wrong

Oh my bad OP I read the wrong type of bearings!

Kenjo, it's cool man! LOL.
Dieselburner - I have something going through atm, I'll let you know if that falls through!

Sourced mine from ROC Bamboo, approx $1600 + vat each side, at N&M was $3800 + vat each side.

My symptoms started as a metallic grating noise as the truck rolled. First thought it was the disc pads but I took off the caliper and inspected - pads and rotors were good.
Then it graduated to a mild knocking noise, esp. when turning to the left (this was the right side hub).

Then it became a soulless, demonic, and god-awful metallic screeching noise and hard knock over the course of the week. It sounded like the metal exoskeleton from The Terminator had a baby with a blender, and the baby was hungry and crying for milk in its metallic, robotic, unhuman voice.



Best way to diagnose bad wheel bearing is to jack up that tire, and wiggle it forwards and backwards, and try turning the wheels left and right. It may shake like it wants to come off the rim - that's a sign that you need to replace the hub on that badass, mother trucker of yours...



Unfortunately it's a sealed bearing, ie. it's sealed within the hub itself - good for low-maintenance but more expensive to replace since the entire hub has to be replace (vs. a simple wheel bearing change in a Mazda B2500/BT50/Ford Ranger PJ/PK).





Don't panic dude, fortunately, your buddy lighthammer is here to help make things easier for yourself and save you time and money.

check this page on the Navara thread for instructions on how to do it yourself. (hint , you'll need a heavy hammer to get that hub out... not just a "light hammer".... get it? Ha!!)

http://www.trinituner.com/v3/forums/viewtopic.php?f=41&t=236360&start=1110


If you have any questions, feel free to PM me.
Hope you get through man, and get back to enjoying that awesome truck!!

^^^^ we said your name a few times and you appeared

lol but someones wheel bearing will eventually need changing so good thing we had a little resurrection here

Faiz in Marbella has the bearing, think its 1K or somewhere there, I bought a 4WD Navara upper cradle yesterday for $375

Thanks for the assistance guys!
Much appreciated....made a few calls...did what I could and she'll be back on the road by mid-week!