Rear Bumper
Posted: October 21st, 2013, 9:25 am
Hey guys! Way going thru my portable hdd and just came across some drawings I did for a rear bumper for my IMV Hilux a few years ago. Never got a chance to build it. Got a job abroad and had to sell the vehicle 
Figured I'd post it so hopefully someone can use it. The design was to use 2" sch 40 pipe and fittings.
The material list is:
10' - 2" sch 40 pipe
12 - 2" 45 deg elbows.
Was planning to use 1/4" or 3/16" thread plate for the step area and 3/8" x 4" flats to make the brackets.
Had already purchased a tow hitch (2") to weld under the step area.
Well like I said. hopefully somebody can make use of it! Post some pics if you do.
Figured I'd post it so hopefully someone can use it. The design was to use 2" sch 40 pipe and fittings.
The material list is:
10' - 2" sch 40 pipe
12 - 2" 45 deg elbows.
Was planning to use 1/4" or 3/16" thread plate for the step area and 3/8" x 4" flats to make the brackets.
Had already purchased a tow hitch (2") to weld under the step area.
Well like I said. hopefully somebody can make use of it! Post some pics if you do.