WTK : Best place to buy materials for house wiring...

[Mr. Cheese]

In South -
R&Z for fittings, lighting, cabling, trunking & panels/breakers
Modern Electrical for Conduits, Poles & some cable

[Stephon.]

EDIT: Now reading through Gladiators posts, glad he posted it too, but not much can be said here anyways

Modern Electrical for Conduits

Just make sure you ask for century eslon

[Stephon.]

don't feel the local stuff is any good either eh

I had to buy the heavy armored cable to rewire a house from meter to panel
within a year the insulation on the wires started cracking up
I had to hire a guy to wrap and silicone it over
he had to do it in a somewhat illegal manner as it was the section which is crimped to the mains
and it was an emergency.

needless to say I later found out that it was a common problem and even the great bureau of standards knew about it and did not enforce or make the company pay to fix these problems which could cause serious fire etc.

Um, that's because he used XLPE wire, XLPE is not supposed to be used outdoors because it wasn't made to withstand the heat of the sun. PVC on the other hand wouldn't have cracked up. Pretty sure this is the fault of the electrician.

WRT it being a common problem, yes it is a common problem .......... With XLPE wire, not PVC.

Was it a licensed electrician that did the job?

[The Raven]

bumping this, need about 40ft of PVC 50mm main cable.

[zagie]

have a question for any one who knows, i have about 60' of cable to run from a metered pole to my house panel, want to know what is acceptable by the electrical inspectorate, meaning i know the standard is to dig a trench 2' with a bed of sand etc but where i have to run the cable it has a decking so its a lot of cutting and digging which is costly, is there any other way to run the cable, does it have a special surface trunking for these cables, oh there is a block wall very close to where the cable have to run can i put it in the wall then plaster it up would the inspectorate pass it, any info would help thanks

[ScHoolboySoloQ]

I have to buy a good bit of electrical for wiring. I know about ME so tell me about Mohammed's, Anand's, Boodoo's, Rocky's.

What other stores are there that are reasonable while having good quality. The breakers must be able to handle high loads without overheating.

[Chimera]

if you have the full list in a easily readable format send me it, i could get you a quote with the discount boodoos gives me

many times you would find boodoos has certain things cheaper and modern electrical has certain things cheaper and alisha marketing have certain things cheaper etc.....

to save the most $$$ you usually need to hit 2 or 3 places

[Rovin]

boodoo's reasonable ... they have a WA service so u cud message dem for prices

[ScHoolboySoloQ]

I have some hand-me-down supplies from ME and it seems like decent products but I heard they expensive for the product grades they sell. Trying to save as much money as I can, it all adds up.

[Strugglerzinc]

Watchu mean breakers to handle high load without overheating? That's kinda the principle of operation of a breaker. If it is subjected to load over its rating it heats up and trips.

[Chimera]

Watchu mean breakers to handle high load without overheating? That's kinda the principle of operation of a breaker. If it is subjected to load over its rating it heats up and trips.

Ppl selling some cheap Chinese sheit locally. Bureau of standards steady cracking down on them

[VII]

Fazeer (Mohammmed's) for best quality basic electrical infrastructural products ..

[Dave]

Endorsed!
Always my go to for electrical and even plumbing.

Fazeer (Mohammmed's) for best quality basic electrical infrastructural products ..

[alfa]

boodoo's reasonable ... they have a WA service so u cud message dem for prices

Good prices but crappy chinese LED bulbs and tubes. Bought some 8 foot LED setups with dual pin tubes some years ago, unable to get replacements as all 8 foot tubes now come single pin and single pin ends won't fit the original base. Buy your lights somewhere else

[Chimera]

You can usually easily change the tombstone on the end to the single pin one

[alfa]

You can usually easily change the tombstone on the end to the single pin one

Yes but then it doesn't fit into the original base without having to cut as the single pin tombstone is a bit larger

[The_Honourable]

Any updates for 2025?

Planning to renovate a house in September, full rewire from pole to plug.

[MaxPower]

Any updates for 2025?

Planning to renovate a house in September, full rewire from pole to plug.

Huh

FRAID dem Trini “electrician” bad bad…

Fellas and them too duncey and figure they know everything.

[The_Honourable]

Any updates for 2025?

Planning to renovate a house in September, full rewire from pole to plug.

Huh

FRAID dem Trini “electrician” bad bad…

Fellas and them too duncey and figure they know everything.

Have electricians out here doing jobs without a wireman license

When you don't know is a hell of a thing

[pugboy]

don’t use xlp cabling for mains
use pvc

[VexXx Dogg]

Any updates for 2025?

Planning to renovate a house in September, full rewire from pole to plug.

Robust electrical limited
Deena Gonzales
Licensed electrician

They can supply and install, but you can shop around at Boodoos, Modern electrical, and even bigger hardwares like Ramlagan, Bhagwansingh’s or Allied for best pricing.

https://www.facebook.com/share/18NmCpwg ... tid=wwXIfr

They did a new install whole house/ 2 floor for me within the last 6months so I’m giving firsthand recommendation.

[The_Honourable]

Any updates for 2025?

Planning to renovate a house in September, full rewire from pole to plug.

Robust electrical limited
Deena Gonzales
Licensed electrician

They can supply and install, but you can shop around at Boodoos, Modern electrical, and even bigger hardwares like Ramlagan, Bhagwansingh’s or Allied for best pricing.

https://www.facebook.com/share/18NmCpwg ... tid=wwXIfr

They did a new install whole house/ 2 floor for me within the last 6months so I’m giving firsthand recommendation.

Thanks for this Dogg

Liking their work as seen on their facebook page

Shopping around for 30ft pole, meter base, cable and panel

[sMASH]

Got good prices from light house , in sando.

[VexXx Dogg]

Got good prices from light house , in sando.

I shopped sales and got lotsa good fixtures on discount.

CE Tang Yuk
Lighthouse
Lighting gallery
Lighting paradise
Edison

The great thing about those companies is that their social media pages or websites are fairly updated so you can look out for sales and take advantage.

For my stuff I was targeting sales nearly a year before for the fancy fixtures and chandeliers and literally saved thousands.

Some of those listed would have sales coming up for independence, divali, Black Friday and Christmas.

Shop smart, save $$$$

Of course this won’t work for core stuff like wiring, conduit, regular boxes, switches, panel, meter base etc. Just the fancy stuff if so desired

[shake d livin wake d dead]

Any updates for 2025?

Planning to renovate a house in September, full rewire from pole to plug.

Boodoos was a go to for me. A bonus was having my electrician registered with them, got some nice discounts through him.

[Dizzy28]

Got good prices from light house , in sando.

I shopped sales and got lotsa good fixtures on discount.

CE Tang Yuk
Lighthouse
Lighting gallery
Lighting paradise
Edison

The great thing about those companies is that their social media pages or websites are fairly updated so you can look out for sales and take advantage.

For my stuff I was targeting sales nearly a year before for the fancy fixtures and chandeliers and literally saved thousands.

Some of those listed would have sales coming up for independence, divali, Black Friday and Christmas.

Shop smart, save $$$$

Of course this won’t work for core stuff like wiring, conduit, regular boxes, switches, panel, meter base etc. Just the fancy stuff if so desired

The Lighthouse in Pasea closed down recently and had a sale on all their items. Some really good deals for those looking.

Really don't miss the days of going Lighting Gallery , Lighthouse , Bright Ideas and Lighting Paradise all in the space of a few weeks because one didn't have the right down lighters or the other didn't have a nice chandelier. Up to me was regular screw sockets and some led bulbs.