:::W.T.K Who can mill this?:::

[Polydor]

As pictures I'm looking for someone who can mill or even make this out of plastic.

It's essentially three plastic rings that all interlock via small lips as seen in pictures.

Any information or whoever can point me in the right direction would be greatly appreciated.

Thanks in advance.

[ruffneck_12]

https://www.facebook.com/qualitechcnc

they do mostly metal work, but I am sure they know some people who can do it or they can make it for you

[Rory Phoulorie]

Try Lo-Tec on Orange Grove Road in Tacarigua.

[pugboy]

hard to figure it out from those pics
I thought lotec was more into supplying materials

[Hook]

I know Lo-Tec sells the lexan/acrylic to make this, but I'm not certain if they machine it

unfortunately they don't open on weekends though, so you'll have to check them on Monday
640-4918

there's a 2nr down south that does plexi/acrylic/lexan work, but the name escapes me at the moment

ANSA TECH limited also sells the sheets, but again, I'm not certain if they do the machining...they may be open 2mro

652-3571

1/4" $850.00
1/8" $445.00
3/16" $695.00

CLEAR

[TK!]

might be better off searching online. fancy water jet cutters etc.
eg - http://www.emachineshop.com/

[Polydor]

Many thanks everyone I'll check out the leads.


There is a shop somewhere on tumpuna road I was told anyone has a contact the guy is a machinist can't remember his name but was told he's damm good.

regards.

[janfar]

MIC should be able to do this.