Flow
Flow
TriniTuner.com  |  Latest Event:  

Forums

Help with Ford Focus 2

From Escorts to Rangers - First On Race Day

Moderator: 3ne2nr Mods

TR3AD
Riding on 13's
Posts: 3
Joined: November 8th, 2009, 11:36 am

Help with Ford Focus 2

Postby TR3AD » July 28th, 2012, 12:02 am

Guys

I need you feedback on a situation with a automatic ford focus (2?) (PBY Plates), Engine: 1.6L

Issue:
When driving on the lady young or any other hill, the vehicle has a low acceleration, Less then 50kmph with RPM < 3000.

If I am a a light, I am typical last of the mark, depressing the accelerator firmly to get a decent movement only makes the engine scream RPM hits 4200 rpm but it about 25 to get up t0 70kmph.

I have taken the vehicle to FORD but there are no errors. The throttle body?? has been checked but the mechanic indicates that this is not an issue.

The engine does NOT overheat and remains pretty much dead center. They think it may be the catalytic converter, but can offer no firm ideas.

Any suggestions? Let me know if I missed out an critcal information, newbie at this.

Thanks

User avatar
zoom rader
TunerGod
Posts: 30518
Joined: April 22nd, 2003, 12:39 pm
Location: Grand Cayman

Re: Help with Ford Focus 2

Postby zoom rader » August 6th, 2012, 8:17 am

Dude, Check you coil, coil wires and spark plugs. Does you engine stutter when accelerating on flats? problems going up steep hills?

ase_tt
Ricer
Posts: 25
Joined: November 18th, 2006, 8:35 am
Location: Trinidad & Tobago
Contact:

Re: Help with Ford Focus 2

Postby ase_tt » September 9th, 2012, 8:46 pm

i have similar problem, will change leads and coil and see if that helps

ModMania
Trinituner Peong
Posts: 409
Joined: January 28th, 2013, 9:18 am

Re: Help with Ford Focus 2

Postby ModMania » July 16th, 2013, 8:04 am

Just an update, i did a full service and used amsoil foam to clean out intake.... My cat is bad but not that bad, the check light is on though... Anyhow plug wires and coil good... Full tank of premium. When service was done tappet cover gasket had a leak so that was changed. I realized tho that my car was still pinging...and no power between certain gears, i would have to go in tiptronic and gear down to get power... A diagnostic scan showed no errors beside my cat... So i went ahead and changed all my shift solenoids in the transmission...so far gear shift smooth and power response is much better... I will have to have a new exhaust manifold made with new cat

Advertisement

Return to “FORD”

Who is online

Users browsing this forum: No registered users and 1 guest