The Official CS Lancer Thread!

[Biggs3ne]

^^^^ It broke up in your hand because you probably squeezed the pliers to hard and broke it when you were trying to unlock it...

I serviced my IAC sensor many times without fail, even the one from the 4g15 DOHC CK engine when I did my swap..

@ Moses, There is a thread in this forum that will take you through step by step on how to service the unit..

[kjaglal76v2]

Lookin to purchace an AWD roro cs lancer, i lookin for somebody to service the tranny i.e open it & change the filter,flush etc.

Who cud do that & @what avg price!!

[icefox]

^^^^ It broke up in your hand because you probably squeezed the pliers to hard and broke it when you were trying to unlock it...

I serviced my IAC sensor many times without fail, even the one from the 4g15 DOHC CK engine when I did my swap..

@ Moses, There is a thread in this forum that will take you through step by step on how to service the unit..

I dint even use a pliers I was using my hand an it does get brittle

[BrotherHood]

Lookin to purchace an AWD roro cs lancer, i lookin for somebody to service the tranny i.e open it & change the filter,flush etc.

Who cud do that & @what avg price!!

Jenton's. Bout $1400.

[kjaglal76v2]

Lookin to purchace an AWD roro cs lancer, i lookin for somebody to service the tranny i.e open it & change the filter,flush etc.

Who cud do that & @what avg price!!

Jenton's. Bout $1400.

Thnx pal

[mety57]

hey all whats up by chance does anyone have the speakers grills for the cs back dash

[turbo_beast369]

^^^what colour?

[mety57]

grey in colour

[BrotherHood]

Does anyone have the dual or triple gauge pocket that fits below the temperature controls?
I want to relocate some gauges and change up the look.

[jason1984]

Guys, when I accelerate my car begins to jerk back and forth. What causing that? Bad Fuel?

[Biggs3ne]

Bad Tranny

[jason1984]

Bad Tranny

I was doing a lil troubleshooting and I saw one of the of the contacts in the spark plug wire falling apart so I going to buy a new one tomorrow and hope is that was giving the problem.

[jason1984]

What is the best brand of coil pack and spark plug wires to buy for the 4G18?

[Dave]

Original Mitsubishi

[Nidish]

Hey guys, I'm from Mauritius and I just bought a CS3 Lancer with 4G18 engine. I'm thinking of changing the spark plugs to iridium NGK BKR6EIX-11 as compared with my current bosch super 4 ones. Will I need to upgrade the ignition coils and spark plug wires considering I'm putting Iridium plugs in? Also a mechanic told me to put K&N CAI and an air compressor to increase power of the car, is it advisable? Thanks

[ZeroOne]

Spark plug wise the iridium don't really make a difference. If you putting them there is no need for new coil packs etc.

[EVA Unit-01]

^^^x2 It would be better performance wiser to match the spark plugs closely to the octane rating on your fuel for maximum efficiency. I've been running the E3 extended life plugs for a while with no problems.


Also guys, doing my big service at 180K km and found the part numbers in the front most helpful. Here are a few i didn't see

[ZeroOne]

My Cs doing over 250k and I never changed tensioner, next time for that

[Dave]

Your timing would be very off. Car would feel very different when u do change

[BrotherHood]

Does anyone have the dual or triple gauge pocket that fits below the temperature controls?
I want to relocate some gauges and change up the look.

Also looking for the center cap for the OEM 14" rim.

[ZeroOne]

Still have my OEM 14" not selling for nothing

[kjaglal76v2]

Fellas i.need a dipstick

[BrotherHood]

Fellas i.need a dipstick

So do I. I used epoxy on mine for the time being.

[nervewrecker]

Pic of it?

[ronsin1]

Pic of it?

the frig you want a pic of the man dipstick

[ZeroOne]

^^^^LOL LOL I thought was me alone wondering that

[PapaC]

Anybody havea contact in the ANSA/DM Body shop in Chagaunas that can help me out?
Getting so much run around right now is a shame...

[chosen1]

ALSO WHERE CAN I GET FRONT ROTOR DISC FOR A CS LANCER???

Seenath's, Dollar Savers and Bobby's in the Bamboo have rotor discs. Bobby's even have a cross drilled and slotted rotor for about $700 a pair.

Anyone know where in south i can get rotors? ...mines are warped and need replacing and i do not want to make the highway run with them.

[BrotherHood]

Pic of it?

Dis eh look too right

[nervewrecker]

I'm serious you know.

Mine had a small hole through and through it and through the metal.
I take a stiff piece of wire that is almost the diameter of the hole, bend it and send it in.
Never came out again.