Flow
Flow
TriniTuner.com  |  Latest Event:  

Forums

ck4 issues after paint job

Mitsu Lancer, Evo, GSR, MIVEC, 4G**, GDI, Galant, Outlander, L200 Sportero/Triton etc.

Moderator: 3ne2nr Mods

Javedali
Ricer
Posts: 28
Joined: November 19th, 2008, 9:52 pm

ck4 issues after paint job

Postby Javedali » January 30th, 2012, 12:44 pm

ok like the post said i am a 1999 ck4 lancer local with a 4g92 engine the car was pre serviced before the paint job i collected cat yesterday and this is my issue when the car reach between 40-60mph the N-neutral green lights starts to flash on the dashboard and the engine would neutralize itself the car slows down come to a dead stop and all i remain doing is reving i have to place the car in neutral or park switch off start again and then proceed somethings in a lower gear.Any ideas peps

User avatar
altec
I LUV THIS PLACE
Posts: 1060
Joined: April 18th, 2003, 6:40 pm
Location: Land of Destruction

Re: ck4 issues after paint job

Postby altec » January 30th, 2012, 1:32 pm

get the car scanned because it is going into limp mode. tranny caused the same thing with mine years ago.

User avatar
BrotherHood
TriniTuner 24-7
Posts: 8250
Joined: October 20th, 2010, 2:41 pm
Location: Bringing HID & LED to a location near you! 355-3165. 704-5442 (WhatsApp).

Re: ck4 issues after paint job

Postby BrotherHood » January 30th, 2012, 10:26 pm

Well definitely the transmission. Do what ^^^he said.

dutyspeed
3NE 2NR for life
Posts: 143
Joined: February 27th, 2008, 9:29 am
Location: in de bush

Re: ck4 issues after paint job

Postby dutyspeed » February 17th, 2012, 10:01 am

agree get it scanned

User avatar
ruffnek
Trinituner Peong
Posts: 440
Joined: January 14th, 2005, 11:24 am
Location: Bumper 2 Bumper

Re: ck4 issues after paint job

Postby ruffnek » February 17th, 2012, 11:18 am

scanned
also check if any sensor wires loose

Advertisement

Return to “MITSUBISHI”

Who is online

Users browsing this forum: No registered users and 3 guests