trinituner.com

ANY ONE i have a 1999 noha with a 3s fe RwD. Van was working good
no probs untill it stalled. Ok lets go van cut off and never started back
only tumberling not running @ all so i change the fule pump, cleand the injector,s
then change them check all sensor even change the crank sensor thinking it was bad
the timming is correct all fues good. Can any one guide me to some help who no,s
about this ride.

Was any diagnostic scan performed?

Hmmm. Yea do a scan. Check normal things like electrical, fuses, clogged lines, ecu... and so on. Also, it looking like your keyboard malfunctioning so you might want to replace that too.

Well ppl thanks for the info. It was a bent valve dont no how that
happen but its in the shop geting sorted out.

Hope you update this thread with -What caused bent valve infor.
Normally,the source is the timing belt either broke,teeth were stripped or improper installation.
This may help to alert other tuners about what they need to be careful with.

Op needs english lessons....just saying.......Isn't it a NOAH?...