Page 1 of 1
rear disc barkes for tercel
Posted: July 19th, 2007, 9:23 pm
by Slow Poke
what can be used also if i'm putting in a 4efte into a carb tercel what additional do i need to get
Posted: July 20th, 2007, 10:29 am
by Terran
I believe the Starlet EP82 brakes setup can work on a conversion for a Tercel. Will check it out and post later.
Posted: July 20th, 2007, 12:29 pm
by Slow Poke
thanks
Posted: July 20th, 2007, 3:53 pm
by Terran
Yep, seems that the Starlet setup is your only practical choice.
Check out
www.tercelonline.com. They have a few posts about that same conversion that may give you some guidance.
Posted: July 22nd, 2007, 2:02 pm
by shinakuma
Starlet rear end bolts up bolt 4 bolt. Front rotors are bigger and again bolt 4 bolt. Engine install bolt 4 bolt. Shocks and springs, Shifter and pedals,master cylinder, starlet fuel pump etc all fit bolt 4 bolt u jus gotta love TOYOTA they design it great d 1st time and jus build along d same platform. Good luck and remember TRD Rules.