
soooo.....looking to build again in a few months....the 3 way realm tickles my fancy quite a bit.
But my problem....deck is 2 way active.
suggestions?
I was thinking:
redo the doors with 8's for midbass and put a 4" mid in the kick. Both run off the rear / low / mid of the head unit and amplified by one 4 channel. Split the signal to feed the amp, high pass for the 8" and low pass for the 4" is set up by the deck. The amps onboard xovers will low pass the 8" and highpass the 4".
Thing is...with drivers on the doors I need TA to get it right but with mids in the kicks...very little TA. I am willing to tweak with TA to suit but can both drivers (on each side) be TA as one without messing it up if both drivers are installed close together?
I can
try to get the pld almost equal by bringing the 4" closer to me and installing the 8" in the doors.
Or the next option, door pods thingy for shallow mount 8's and install them near the edge of the door nearest the kicks and install the 4's nearest the doors so they almost next to each other.
I looking at 45hz - 100 maybe 150 for the 8's and 100 maybe 150 - approx 7khz for the 4", willing to experiment with the faital 4" and havent made up my mind on some 8's yet.
thoughts, comments, advice?