trinituner.com

Ok tiida tech fellas:
I took off the battery pole to change my deck after changing it i put back on my battery pole and when i turn on the key im getting ignition the headlights and fan coming (it not supposed to) but no crank, all the fuses good did a scan and it showed a P1610 lock out code. none of the windows or lights working with the switch with the ignition on. it has a smart key but the fob not working so im using the key alone.
and the car was working good before..

ESCAPE FROM LOCK MODE
1. Turn ignition switch OFF.
2. Turn ignition switch ON with registered key. (Do not start engine.) Wait 5 seconds.
3. Return the key to OFF position.
4. Repeat steps 2 and 3 twice (total of three cycles).
5. Start the engine.

Try this and see if it works

cosmo wrote:ESCAPE FROM LOCK MODE
1. Turn ignition switch OFF.
2. Turn ignition switch ON with registered key. (Do not start engine.) Wait 5 seconds.
3. Return the key to OFF position.
4. Repeat steps 2 and 3 twice (total of three cycles).
5. Start the engine.

h

Tried it and nothing.

You may have to get the system reprogrammed

krossbreed wrote:You may have to get the system reprogrammed

Them key programming people does do that ?

Yep.

Found the problem it was a broken wire in the main harness. Happened while passing the 4 gauge power cable.