Page 1 of 1
WTK correct battery size
Posted: September 19th, 2013, 6:08 am
by hindian
Morning all, trying to find out what's the correct battery size to use in a b13 with a b14 conversion. The battery in it is dead and I suspect it's the wrong size as the previous owner flattened out the battery stand to fit a 13 plate for music thanks...
Re: WTK correct battery size
Posted: September 19th, 2013, 9:23 am
by skibz
If you don't have any amps running then use a 13 plate. Should be roughly 7 something for a maintenance free one.
Re: WTK correct battery size
Posted: September 19th, 2013, 11:09 am
by Sundar
make sure n get a battery wit the correct pole configuration , that when you put it in the positive pole is on the engine side n not close to the body. i think urs would be a "left hand battery"
Re: WTK correct battery size
Posted: September 19th, 2013, 11:23 am
by hindian
I got through fellas, i bought a 13 plate Yuasa 650 cranking amps but it small enough to fit the battery stand and use back the original clamps. Thanks all
Re: WTK correct battery size
Posted: September 22nd, 2013, 10:24 pm
by hindian
Fellas where can I get an A/C blower card to buy new for the same vehicle? I've been trying used ones and they not holding out. Any help would be appreciated thanks.
Re: WTK correct battery size
Posted: September 23rd, 2013, 12:39 pm
by wagonrunner
you eh wanna find out why they're not holding out?
Re: WTK correct battery size
Posted: September 24th, 2013, 4:21 pm
by hindian
Well I'm assuming because they are used? Cuz I checked out the electricals twice before with the same problem and both times there was nothing wrong with the wiring. The problem is when I install the card, the blower speeds work fine and after a few months I notice the speeds start to slow down as in the highest speed feels like it's on the slowest setting...
Re: WTK correct battery size
Posted: September 24th, 2013, 5:07 pm
by wagonrunner
i hear you but unlikely if you keep replacing one component, that component is the problem.