Postby ramishrrr » April 19th, 2011, 7:01 pm
The criteria I use for choosing aftermarket brake pads are:
1. The colour of the lining. I go for light colour, as the dark colour does not permit you to see 2. below.
2. The sintered metal content. This is most likely copper particles for metal-to-metal contact with the rotors for more friction, hence stopping power. The softer metal copper will wear, rather than your rotors.
3. If there is a centre groove, good ! However you can cut one with a hacksaw before installation. Helps with dust-dissipation.
4. Expensive does not make it superior.
Regards,
RR.