Page 1 of 1
SR20VE / CVTM6 in P11 Wagon Power problem
Posted: December 30th, 2010, 9:45 pm
by Kasey
So I got a Primera P11 with its original SR20VE / CVTM6 tranny. Recently I am having this 'lazy pull of' probem. I am experiencing this power problem and I did nothing rcently so I am thinking somm went bad.
I got the car scanned by Steve (Ben lommond village), and the scanner din pick up anything fault in the tranny or the engine.
Thing is, I changed the speed sensors, and the stepper motor(whatever it is called)earlier this year due to sticking gears. When I changed these stuff, the CVT worked fine. So now when he car is moving the gears change and dont stick so I didnt think it was the tranny.
Also when I am going uphill, I have to mash the gas harder than usual.
Checked fuel pressure, air filter, plgs, injectors clean, everything ok.
Any other ideas?? Could it really be the tranny??
Re: SR20VE / CVTM6 in P11 Wagon Power problem
Posted: December 30th, 2010, 10:11 pm
by Anil_Sooknanan
dropping resistor
Re: SR20VE / CVTM6 in P11 Wagon Power problem
Posted: December 31st, 2010, 8:24 am
by Kasey
^^ hEY thanks for the prompt response Anil. Where is this 'dropping resistor'? Is it expensive? Can I change it myself? I do minor work on the engine myself so I know my way around a little.
Thanks again man.
Re: SR20VE / CVTM6 in P11 Wagon Power problem
Posted: January 3rd, 2011, 9:35 pm
by Kasey
Anything?
Re: SR20VE / CVTM6 in P11 Wagon Power problem
Posted: January 4th, 2011, 11:32 pm
by Furlz
Here:

Re: SR20VE / CVTM6 in P11 Wagon Power problem
Posted: January 5th, 2011, 12:42 am
by Stay Tuned
Some very informative stuff there, I think my oil pump oil seal leaking.
Re: SR20VE / CVTM6 in P11 Wagon Power problem
Posted: January 7th, 2011, 11:02 pm
by Kasey
update, I have realised that when the Air condition is on, the pull off is even lazier!!
Strange thing tho. Sumtimes the car work fine pullin off good and ting, and all of a sudden, it pulls off lazy again. The othe day, I stopped on a hill and could move, with foot X to board, and the car was stalling. It was like the RPM was staying at 1200.
I turned off the car the put back on and it after bout a miniute, and it went up the with no problem!!
These intermittent problems are so hard to trouble shoot.
Re: SR20VE / CVTM6 in P11 Wagon Power problem
Posted: January 8th, 2011, 11:02 pm
by d_ad_man
with these cars or should i say these sr20ve with cvt. You cant mash the x right down when goin uphill. u will not get any power. Mash it moderate then it will build.
Re: SR20VE / CVTM6 in P11 Wagon Power problem
Posted: January 9th, 2011, 8:39 am
by Kasey
^^the reason I mash right down, is because I cant go up while mashing moderately. If the car aint moving how hard should I mash? I have to mash until the car starts to move, and thats sometimes when x to board.
Again I re-iterate: I KNOW MY CAR. I HAVE OWNED IT 3 YEARS NOW AND THIS IS NOT HOW IT USE TO WORK!!! The problem is intermittent!!!
Re: SR20VE / CVTM6 in P11 Wagon Power problem
Posted: January 12th, 2011, 3:15 pm
by wilddog
the chain in the tranny stretched
so u will loose power under load
Re: SR20VE / CVTM6 in P11 Wagon Power problem
Posted: January 12th, 2011, 10:16 pm
by Kasey
^^So what explains that SOMETIMES the car works fine??? Normal good power sometimes, SOMETIMES its dead.???