Page 1 of 1
SR20 Transmission Wiring - help needed!
Posted: May 4th, 2009, 1:07 pm
by Stark Auto Rentals
Hey guys,
I have a question with regards to the SR transmission and the wiring.
On the transmission there are three jacks on it.
One has seven wires. The other one has three wires and the last one has two wires.
Can anyone advise me what these wires are for or provide a wiring diagram or any kind of information please?
Posted: May 4th, 2009, 5:01 pm
by Anil_Sooknanan
the one with the 7 are for the Neutral switch and display on the dash. the other is jack is for the Overdrive solenoid and lock up solenoid
Posted: May 4th, 2009, 6:53 pm
by yakuza
And the other one is the speed sensor.
Posted: May 4th, 2009, 9:34 pm
by megadoc1
seven wires -pnp switch
three wire-overdrive and lockup
two wire-speedo signal
Posted: May 5th, 2009, 8:21 am
by Stark Auto Rentals
ok guys, thanks for the info......
i have another question.........
what wires are required for the transmission to actually work and change gears..........
right now, none of the wires are connected and the transmission appears to be locked in 2nd gear.......it's either 2nd or 3rd i believe.
Posted: May 5th, 2009, 10:39 am
by Stark Auto Rentals
guys, here's the whole story. i'm actually helping a friend out.
He had a sr20 engine and transmission in the car.......car is a 626 btw, so no original harness and ecu and stuff.
the transmission got damaged in the car and had to be replaced. the one that was in the car was a cable type transmision.
he got another sr20 transmission and placed it in the vehicle. however, this transmission did not have any kickdown cable. Also, out of the three jacks on the transmission, only one was able to plug back in as normal. that was the one with the two wires, so i assume that is the speedo signal.
now the other two jacks are different from what is on his sr20 harness in the vehicle.
he also got a transmission ecu with the transmission and it looks like this:
my question is does he really need this ecu to be connected for this transmission to work? as it is, with only the speedo signal connected, the transmission appears to be locked in 2nd gear......
the other problem is that he did not get the plug in harness for the transmission ecu so we're really trying to see if we can get it working without that transmission ecu.
Posted: May 5th, 2009, 4:58 pm
by Anil_Sooknanan
Oh gosh yuh coulda say that from B4
Posted: May 5th, 2009, 8:33 pm
by dbaby
oh ok...well for sure you hafta wire in that trans. ecu no two ways bout that so go look for a jack for that trans ecu...
Posted: May 5th, 2009, 8:33 pm
by dbaby
oh ok...well for sure you hafta wire in that trans. ecu no two ways bout that so go look for a jack for that trans ecu...
Posted: May 5th, 2009, 10:40 pm
by Anil_Sooknanan
waste of time and money. you know how much that gonna cost to wire!. you need to tie it in with the engine.
Posted: May 5th, 2009, 11:43 pm
by megadoc1
i had a slight feeling it was an electronic controlled tranny u was talking bout
u got some work to do now
Posted: July 22nd, 2009, 12:51 am
by slackwire26
Hey did u ever got the wiring diagram. i need d same thing. cud u email me @
k.pustam@hotmail.com
Posted: July 22nd, 2009, 8:08 am
by Stark Auto Rentals
slackwire, sorry man, never went ahead with that. I purchased one of the normal tranny's instead and used that.
Posted: July 27th, 2009, 12:01 pm
by demented
Here's the tranny ecu wiring diagram off a P11 Service Manual
Posted: December 22nd, 2009, 5:22 am
by audiopipe
hi
i'm doin the same conversion in a 626 with the same engine an transmission
is there anyone with the colour code for transmission module ?
if so please post it or pm me
Posted: December 22nd, 2009, 3:56 pm
by Anil_Sooknanan
audiopipe, that is the same diagram i got..... what you need now is the pinout when looking at the connector
Re: SR20 Transmission Wiring - help needed!
Posted: November 1st, 2020, 1:29 pm
by Chef1
Hey guys does any of the pnp switch of the cable type transmission go too the brain or any of the sensors besides the neutral switch
Re: SR20 Transmission Wiring - help needed!
Posted: November 15th, 2020, 12:09 am
by Anil_Sooknanan
Lock up solenoid