trinituner.com

I recently installed a pioneer deck in my wingroad Y10 model and only realised that the dash lights weren't flashing when i engaged my viper alarm. The alarm works fine but lights aint flashing. Need some serious help. Bless

Could be a fuse or a bulb probably blow somewhere

Are u gettin park lights?

I checked all the fuse and the park lights work

the dash lights work at all? or you only get the non-function when you activate the alarm? Perhaps you should recheck the deck wiring to make sure you didn't forget to include some wires, or in case you crossed the wrong wires

i only get the non function when i activate an deactivate the alarm. I rewired the deck three times. There is one wire which isn't connected, casue it is the dash wire - meaning: The old deck had a function when you put on the park lights the lights on the deck would come on. The pioneer doesn't have that function. I even tried hookin up that wire to the deck and each time put on the park lights it shorted out the deck.

check every time you use your deck and see if time and setting resets if so swap constant B+ with acc wire

lejane wrote:i only get the non function when i activate an deactivate the alarm. I rewired the deck three times. There is one wire which isn't connected, casue it is the dash wire - meaning: The old deck had a function when you put on the park lights the lights on the deck would come on. The pioneer doesn't have that function. I even tried hookin up that wire to the deck and each time put on the park lights it shorted out the deck.

If it's shortin out the deck jus leave it out!

It seems like that causin u some stress bro.........better u go by ur alarm shop and let them move the wire from the park and put it on the hazzard.

You won't have ur park light problem again and lights will still flash when u arm and disarm ur alarm!

My $0.02

check an electrician... next thing you make it worse.