trinituner.com

ok ppl i need to know where do i purchase the (excuse the spelling) polyuritaine mix to fiil my engine mounts

Same here..im looking for a rear cross member mount, 2x cradle arm bushings, all for a Y11/AD VAN

u can get it at any parts place buy the 3m brand

you have any idea on the cost?

ok well i tried the polly thing and that didn't work instead now when i in traffic the car keeps vibrating while trying to pull off any advice would be appreaciated

^^ Did you fill all the spaces in the mount ? If you did then this is the reason for the vibration at idle. I will suggest cutting some slots in the mount to allow it to flex a bit or just buy the energey suspension mounts, the last long and they don't cause you the discomfort you get at idle.

Energy suspension makes inserts for the mounts. They have inserts for the B13, GA16, and mounts for the B14 QR25DE...I'm still trying to find out if any of those would work on B14 GA15/16 *shrug*

flatline wrote:Energy suspension makes inserts for the mounts. They have inserts for the B13, GA16, and mounts for the B14 QR25DE...I'm still trying to find out if any of those would work on B14 GA15/16 *shrug*

They have for almost every single Nissan vehicle from 1993.. I checked this when I was by ADAH303.

^k...i checked the online catalogue on the ES site last week and saw what i posted. So they have more stuff that's not on the online catalogue then eg. B14 GA15?

^^ Si

flatline, Where can i get the sr20 energy suspension mounts?

SASCO on Cipero Street San Fernando refill mounts....they do a good job...maybe you can check them for advice.