Page 1 of 1
rb20 tranny conversion question.
Posted: July 6th, 2007, 10:06 am
by Naka
For valid reasons, I wanna change an rb20 manual into automaitc transmission.
what i wanna find out is:
1) Is the tranny easily available and at what price?
2) Will it work properly?
3) How hard is it to install?
Thanks guys.
Posted: July 6th, 2007, 10:25 am
by speed king
not that hard u will hav to get the harness for it an a lil re wiring i think an the brainbox for the tranny also (4speed or 5 speed) advise u to go wit the 4 speed short back less head ache to wire up an cost bout 1400
Posted: July 6th, 2007, 11:23 am
by Coldfyah
Also u will have to probably widen your tranny tunnel to accomadate the auto.....its ususally bigger than the manual
Posted: July 6th, 2007, 11:44 am
by ~Street Sleeper~
I could sell u rb20de engine and tranny complete for $5000 if the conversion eh wukkin
Posted: July 6th, 2007, 3:25 pm
by Naka
Is that non turbo? Cuz mines is turbo.
Posted: July 6th, 2007, 3:30 pm
by ~Street Sleeper~
non-turbo.. buy it and use the tranny on your set-up..sell the engine etc after
Posted: July 6th, 2007, 4:17 pm
by speed king
^^^ the non turbo tranny will mash up if he uses it he has to get a turbo tranny an converter... wat car u doin d conversion on ? depends cause u may not hav to widen the tunnel
Posted: July 6th, 2007, 4:20 pm
by ~Street Sleeper~
hmmm..true.. but he could sell the whole motor and gearbox and drop in a full auto system ..legit!