TriniTuner.com | Latest Event:
Moderator: 3ne2nr Mods
Start engine and warm it up until water temperature indicator points to the middle of gauge.
Ensure engine stays below 1,000 rpm.
Turn off engine and disconnect throttle position sensor harness connector.
Start engine.
Race engine (2,000 - 3,000 rpm) 2 or 3 times under no-load and then run engine at idle
speed.
Check ignition timing with a timing light.
Adjust ignition timing to the specified value by turning distributor after loosening bolts which secure distributor.
Considering that is the OEM BTDC, ithe engine will run as designed.Rayan wrote:What will happen if I set the crankshaft timing at 6degreesbtdc with the ga15de engine
wagonrunner wrote:specs.
Users browsing this forum: No registered users and 31 guests