good machine shop?

fafrumlosin · Postby **fafrumlosin** » June 14th, 2005, 7:32 am

i am in need of having my flywheel an PP resurfaced/cleaned as it was slightly glazed due to oil getting on my flywheel and between the clutch disk...could someone piont me teh a good machine shop... someone suggested zaid mustapha an trinidad engineering....i am looking preforably somwhere in el soccoro or close by.

nash · Postby **nash** » June 17th, 2005, 8:14 pm

Well D.Rampersad Engineering does a good job,you can try there is all else fails(671-7267).

janfar · Postby **janfar** » June 17th, 2005, 10:28 pm

check MIC in Macoya, them is the best, then you could check Mustaphas, trust me, we deal with these machine shops on a day to day basis, these guys will machine the mona lisa if they had too. try them, real professional.

nigel1977 · Postby **nigel1977** » June 18th, 2005, 9:05 am

sings engineering in montrose.

thats ravi singh's dad place. they know what they doin over there.

Postby **Team Loco** » June 19th, 2005, 11:24 am

Kennicon in south

cdmg · Postby **cdmg** » June 19th, 2005, 11:47 am

Doh mean to hijack... How "good" is a resurfaced flywheel? How far gone is too far gone?

Picasso · Postby **Picasso** » June 19th, 2005, 3:40 pm

Aiight are they extemely good cause I want to carry am SR20 block to bore out for some bigger pistons and I need precise professional work done

nigel1977 · Postby **nigel1977** » June 19th, 2005, 4:10 pm

well i know that sings do a lot of performance work.
dont tell me you never heard of ravi and sylvan singh???

Picasso · Postby **Picasso** » June 19th, 2005, 4:24 pm

tell me you never heard of ravi and sylvan singh???

Nope never heard of them fellas......... I am new to the speed thing with who to check for performance parts...I was a Car music man... I am intersted in speed from long time is just now I am going into it deep.