exhaust gasket material

[Dave-ve]

tried searching but couldn't find anything.

I need to change the gasket from the primary to secondary pipes on my extractors. I can't get the original gasket used. are there any replacement gasket material that can be cut to be used. engine is NA.

[krack korn]

whats your location and do you have a pattern to trace and cut it out
u can pm or call me at 396 2315

[CD4Accord]

what engine and what brand extractor/header?

That could be a start...

Problem with used gaskets, is that many primary to secondary gaskets are actually crush gaskets, not meant to be re-used...

[Dave-ve]

it's the ssac header for the sr20ve. I will remove it sometime this week.

[VK-Sportsman]

I believe this is what you're looking for.

http://www.sr20-forum.com/general-sr20/36643-need-help-finding-gasket.html

[yakuza]

You can use 20 gauge copper sheeting, Lo Tech hardware in Orange Grove sells it.

[web_phantom]

you can also try dumore enterprises in San Fernando, you can get graphite gasket ends that you can use to cut your gasket.

[yakuza]

I had this one made for my headers from the copper sheeting I was talking bout earlier.

[THE SYNDICATE]

^^^nice!

[Dave-ve]

I got the copper sheet and made a similar one.

0.9mm copper sheet $185 + vat per sq foot.