WTK: Screw Extractor/Drill Bit- trinituner.com

Forums

WTK: Screw Extractor/Drill Bit

Moderator: 3ne2nr Mods

5 posts • Page 1 of 1

Furlz: 3NE 2NR for life; Posts: 113; Joined: July 16th, 2007, 4:41 pm

Postby Furlz » December 2nd, 2009, 11:37 am

Where can I get a set to buy?
Working so don't have time to look around.
Need ASAP.
Thanks.

kurpal_v2: TriniTuner 24-7; Posts: 11904; Joined: December 28th, 2007, 9:17 pm; Location: Chilling with Akeem

Postby kurpal_v2 » December 2nd, 2009, 11:38 am

you tried bhags?

DJ Nexxus: Chronic TriniTuner; Posts: 631; Joined: December 30th, 2006, 10:38 pm; Location: Pushing through the event horizon

Postby DJ Nexxus » December 5th, 2009, 12:45 am

peakes

belalegosi: 18 pounds of Boost; Posts: 2401; Joined: August 19th, 2003, 8:53 pm; Location: MN; Contact:
Contact belalegosi

WLM

Postby belalegosi » December 5th, 2009, 8:18 pm

those things never work good for me.. especially on hardened engine bolts

I usually have better luck with left hand/reverse thread drill bits

chindian88: Sweet on this forum; Posts: 289; Joined: September 17th, 2009, 11:18 am

Postby chindian88 » December 5th, 2009, 10:49 pm

you could try aphzal hardware in el socorro

5 posts • Page 1 of 1

Users browsing this forum: No registered users and 3 guests