D15B 3 stage vtec ecu wirin

civcdrvrinwrx · Postby **civcdrvrinwrx** » April 8th, 2006, 2:23 am

i lookin for the wirin diagram for a D15B 3 stage vtec.
one that shows not only the vtec solenoid wires but also the vtec monitor wires. looked in the helms96-2000 and it was a waste of time.
KES WHERE R U?

civcdrvrinwrx · Postby **civcdrvrinwrx** » April 8th, 2006, 2:25 am

cleriq boss i waitin patiently.
NO PRESSURE OR NETHING.

kes_vtec · Postby **kes_vtec** » April 8th, 2006, 7:50 am

what is the number of ur ecu

Clerique · Postby **Clerique** » April 8th, 2006, 2:24 pm

civcdrvrinwrx · Postby **civcdrvrinwrx** » April 8th, 2006, 10:50 pm

^^^what he said i guess

kes_vtec · Postby **kes_vtec** » April 10th, 2006, 8:45 am

http://www.ff-squad.com/technet/

civcdrvrinwrx · Postby **civcdrvrinwrx** » April 10th, 2006, 9:52 pm

a kes thanks a lot dred

this is extremely helpful. i goin to frame this horse u wudnt believe how hard it was to get this.
thanks a million but i not seein two wires goin to the ecu for each of the two solenoids. i seein one wire for both

u feelin to help me wire it or wa.
ill pay u. :mrgreen:

no seriously ill pay u for the time. u just tell me when and where. check ure pm. call me nah

rudeboye_r · Postby **rudeboye_r** » August 17th, 2009, 11:12 am

kes i have the same problem can you help i put a 3 stage in a non vtec 96 civic and it doesn seem to go into vtec it is real lazy catching my ass to pass 4000. let me know if you help.

Sky · Postby **Sky** » August 17th, 2009, 6:08 pm

civcdrvrinwrx wrote:a kes thanks a lot dred this is extremely helpful. i goin to frame this horse u wudnt believe how hard it was to get this.
thanks a million but i not seein two wires goin to the ecu for each of the two solenoids. i seein one wire for both u feelin to help me wire it or wa.
ill pay u.
no seriously ill pay u for the time. u just tell me when and where. check ure pm. call me nah

If it's the same kinda P2J like mine it should be obd2a

You used the ecu for that engine right? If for some reason the swapper didn't use the 3 stage harness then you'll have to run the wires yourself.

rudeboye_r, did YOU use the P2J ecu that came with the engine? If you did then you can just wire the 1st solenoid to ign on so you can use your 16 valves, because from the rpm it sounds like you can't leave your 1st stage. IF you really have a nonvtec ecu then do the above and take strain without vtec :lol: