Postby narrie » March 22nd, 2015, 3:55 pm
Ok i got it working again.
Steps how to recalibrate temperature and fuel guage needles:
Temperature:
-remove needle
-start car and wait for radiator fan to come on thats an indication that engine temp at run temp.
-insert needle at set at point were it usually read when car is warmed up. fully push in needle when you at the right point
Note: if when you try to push the needle down and its not going dont force it. set the needle a little higher or lower and try pushin it all the way down do this until you get it all the way down.
Fuel:
-remove fuel guage needle
-fill gas tank
-insert needle and set at full mark.