Page 1 of 1
Re: help needed ek3 belts not turning
Posted: December 26th, 2010, 11:55 pm
by speedfreak44
hmmm
1) crank shaft bolt fall out/ run slack
2) keyway for or craft shaft and pully damaged
Re: help needed ek3 belts not turning
Posted: December 27th, 2010, 12:37 am
by HondaR
Did you change the timing belt recently
The above as pointed out by speedfreak usually happens after changing the timing belt and u don't use locktite to tighten the crankshaft bolt.
Re: help needed ek3 belts not turning
Posted: December 27th, 2010, 7:03 am
by speedfreak44
depends on how damaged the pullly or crank shaft is. the crank shaft could be rebuild but is alot of work. if the pully and key damaged its easier to replace