trinituner.com

i have a set of projectors headlights for my eg8. how do i focus the lights on to the road. because the light is showing up in the air. i know u have to turn some nut/screw but i am seeing a few things that i can turn and dont know which one it is. plz help

bump

Normally it's just what u said. A screw or nut which is typically seen from the top of the housing. Depends on what brand lights you bought tho... can u post a pic of the housing ?

Be careful in adusting them, I had a set that when adjusted, it came off the gear when turned too far the wrong way !

i will try to post a pic of it then . thanks

yea post a pic.. i had de same prob with my previous set, but found them and adjusted them to suit

You might see a couple screws on one light.....left and right adjust and up and down adjustment

thanks people . i got through with it. it had three sets of screws on the high beam light and 2 sets of screws on the low beam. when i actucally drive the vehicle i know if it was adjusted properly. from before i adjusted the light to after the reflection from it on a wall came down almost 12inchs. i think the brand is clr from by bobbys auto.

I have the same problem. These are what the back of my projector case looks like, as well as the front. I got them from Bobby's.:

http://i493.photobucket.com/albums/rr29 ... CT0030.jpg

http://i493.photobucket.com/albums/rr29 ... CT0033.jpg

http://i493.photobucket.com/albums/rr29 ... CT0039.jpg

Hope I can get some advice.

Thanks.

focus on a wall... should not be higher than bonnet high

the best way i focus mine was in the road at night time. so i could of seen how far the light was and the width of it. take care when focusing the high beam, cause the screws can fall of the lens when adjusted to much.

BUMP

Could I do the same screw method with the Ek3 ?

I replaced my originals with the "OEM" ones sold by Bobbys...I was thinking that they probably suck guess they just need adjustment

Thanks