Page 1 of 1
SIR front hub 4 eg4,6&9
Posted: August 2nd, 2009, 8:04 am
by MrD15Bvti
Yeah ppl, want to know if the SIR front brake set up will work on an eg, if it is an improvement, where can i get a left side and how/where can i get d rotors resurfaced???
Posted: August 2nd, 2009, 10:32 am
by bluesteel29
i got some normal brembo SiR rotors 4 sale
Posted: August 2nd, 2009, 12:33 pm
by ksimon
how much u want for the rotors...???? are they slotted or dotted???
Posted: August 3rd, 2009, 6:54 am
by MrD15Bvti
anybody else??
Posted: August 4th, 2009, 11:27 pm
by High_Speed_Imports
got eg9 complete spindle good condition coming off a half so no ware locally
Re: SIR front hub 4 eg4,6&9
Posted: August 5th, 2009, 7:46 am
by paz
MrD15Bvti wrote:Yeah ppl, want to know if the SIR front brake set up will work on an eg, if it is an improvement, where can i get a left side and how/where can i get d rotors resurfaced???
putting bigger brake without putting the correct master cylinder/booster and proportioning valve not really making much sense .
you can buy eg9/ek4 spindles for anywhere from $500-$1000 personally i aint paying more than $700.
best thing you can do is to raid a front cut for the front and rear brakes as well as the mastercyl and prop valve..
eg9/6 and dc2 would be direct bolt ins.
you can get the rotors machined at any machine shop .
it should cost around $150