Page 1 of 1
LS vtec oil supply
Posted: July 11th, 2008, 12:32 pm
by N1
Where can i obtain a tee to fit in the original oil pressure unit location. Any one can help? It would be appreciated. Tee must NOT be brass though.
Posted: July 11th, 2008, 1:00 pm
by N1
bump
Posted: July 11th, 2008, 4:01 pm
by De Dragon
Check Trinidad Hose or any hydraulic supply place.
Posted: July 12th, 2008, 3:36 pm
by trincivic
It will be very difficult. The original fitting is a 1/8 BSPT fitting. You should get a 1/8 NPT tap and retap then use readily available 1/8NPT union and tees
Posted: July 13th, 2008, 12:53 pm
by red_dragon
Trinidad hose carrying AEROQUIP FITTING little costly
but i got all mine there to run the oil line
Posted: July 13th, 2008, 8:48 pm
by De Dragon
Posted: July 13th, 2008, 9:30 pm
by red_dragon
^ actual I was goin with that but time did not permit
you are better off buying the kit if you have to but the things separate or locally it gonna cost lots more