i recently change the timing belt as well as the seals.i am getting a rought idle now i just want to know the position of the timing marks to check back the timing to ensure that it is timed correctly .
i will like to know the procedure to reset the tps to the stock setting ,i had a inexperience mech alter it and would like to set it back reasons that now when driving down the highway the car surges at times and get flat spots at times can someone direct me to some one to reset it .thanks
yeah its real stress tries to look for air leaks and stuff and no leaks ,but will check the battery and the alternator but could you advise me of a good mechanic for the 20v
last night i filled up and 84.00 for 350 km so i guess its burning ok .another thing its that i have a cutting off problem when stopping it sometime idle real low and cuts of but it starts back in a one,and when driving in the night and i put on my lights its like the engine lose power you have to p...
just asking for some guidence i have a 20 v silver top and it does not idel properly.when cold it starts in a one and idles and as it reaches the operating temp it stutters and dies and when you rev up once and tach go up and come down and cuts off all together .what is the problem ? i change the ai...
ok cool thanks Big Z ,another question the b 14 is bolt for bolt > just to take of the rotor and calipers only and replace with the b14,reason i asked i see you recommended the y11 ad SPINDLE ,rotor and calipers ,thanks much for the response.
Good day ,i have a Nissan b 12 and the front right outer disc pad is cutting faster than the rest of the pads .What is the problem? i did a search and came up with the inner one cutting faster and it was said that the pins have stuck ,is this the problem for the outer one as well ? thanks
i have a nissan e15 engine and need to find the idle up for the ac.i have asked around and some say its located under the carburetor ,is that correct? .I looked and saw two units where 2 yellow wires on both sides it that the unit for the idle up ?thanks
i have a e15 installed in a b12 pay series.when i turn on the ac it does not idle up .what is the problem? i had someone with a little knowledge said that i need to put in something in the carb and run some lines to a unit i have on the fire wall can someone help me identify that part on the carbure...
when i reach about 80 i get a vibration continuous its not the tyres or the rims bent i check that already i change the ends joints etc what could be the problem could it be the tri pod i think its called gone out or the mount i have a b 15 .also when i start and change to drive its take a while for...
i have the suzuki for about three years and no problem with the rims , change the steering box to power steering and i have the damper on the pit man arm.
i have play on the front wheels on a suzuki samurai wanted to know how to change them as well as the wheel bearings or if some one could give a contact number for someone to change them
i jacked up the front wheels and rock it top and bottom and side ways and it moving i am thinkin its either the king pin bearing or the wheel bearing thanks ! the question is now how to change the king pin bearing ??
i have a suzuki samurai,when driving down the road and 60 and over i get a really bad shim on the steering and when you look out side the wheels just wabbleing whats the problem ? i check all the joints from pitman arm to all the joints.could it be the steering column it self from the steering to th...
i have a suzuki samurai,when driving down the road and 60 and over i get a really bad shim on the steering and when you look out side the wheels just wabbleing whats the problem ? i check all the joints from pitman arm to all the joints.could it be the steering column it self from the steering to th...
