help needed

[ST Auto]

how do i connect:
1) 2 8ohm speakers to give a 4 ohm load on a 4channel amp

2)4 8ohm speakers to give a 2 ohm load on a 4channel amp

also can a power acoustik demon 2400 play 4 8inch 18sounds o will it play 2 8inch and 2 6inch 18sounds better???

[Ted_v2]

i have a demon 2400w demon and it was playing 4 8"eminence (m&m) good so it should play ok but not to full potential

[ST Auto]

how 2 wire 2 8ohms 2 4ohms?

[Firewall]

wire them in parallel.........for both situations that you asked about.

if you want actual wiring diagram check the RF site woofer wiring wizard

[ST Auto]

ok my amp says 1200*2 bridged at 4ohms..... so two svc 8 ohm speakers connected in parallel = 4 ohm load....how do i connect the 2 8 ohm speakers on a 4 channel amp bridged at 4 ohms??

[smaharaj]

positive to positive,negative 2 negitive,it will bring the 8 ohm and 8 ohm 2 a final load of 4 ohms

[ST Auto]

so ur bridgin channel 1 and 2 and channel 3 and 4?

[supanats]

It's a 4 channel amp right, in bridged mode you get two 4 ohm channels.Channel 1 & 2 bridged form the first channel. Channel 3 & 4 bridged form the second channel. Your choice is to use one bridged 4 ohm channel to power your pair of subs, the subs are paralleled to form one 4 ohm load. The other bridged channel can be used to power something else utilizing that amount of power at a 4 ohm load or you may choose to un-bridge that one channel and power some separates, coaxials whatever, at a lower power demand in 4 ohm or 2ohm.

[theblitz]

OR you can run each sub on a pair of bridged channels. (Ch1+2 TO ONE SUB, 3+4 TO THE OTHER)
The power can be estimated by summing the 4-ohm power output for a pair of channels for an 8-ohm load in bridged mode.

[ST Auto]

^^ok the amp is a demon 2400...and wel its not sub...its 2 8 inch bnc...what will be d better choice...?run each 8inch on d pair of bridged channels? or use 1 bridged 4 ohm channel 2 run both 8 inch?

[smaharaj]

bridge dem,u will get mopre out put,eack speaker is 8 ohms,so wen u bridge yur amp,power will split half and half on yur 2 speakers,so running the 8s on d pair of pair of bridged channels will jus be wasting 2 channels,so 1 bridged channel will do d wok!

[ST Auto]

bump..

[casper]

^^^breds...yuh dun get d answer to ur question already...wah more u want???